![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
ショートカットのアイコンをクリックしてMarcを立ち上げても、
Security check failed!
Check that the license server is running or contact MSC Software Support.
OK
と表示され、起動しない。 コマンドプロンプトには
License server is not at or above the minimum required version. Verify that your license server is at FLEXlm version 11.13.1.0 or above
と表示される。
▸時間を空けて再起動したら、問題なく立ち上げることができた。
もしかするとサーバーが落ちていて、それが復旧したために起動できるようになったのかもしれない。
＜終了番号：3015＞
Unable to reduce the time step below the minimum value allowed, and to still satisfy the user criteria in the AUTO STEP history definition option. Either change the criteria or reduce the minimum time step allowed.
ー時間ステップを許容される最小値以下にすることができず、なおかつAUTO STEP履歴定義オプションのユーザー基準を満たすことができない。ー
解決策
＜終了番号：3002＞
Analysis has failed to converge to required convergence tolerances. One of several error conditions has been detected and the run aborted. The output will specify additional messages.
ー解析が収束許容値に収束しなかったー
解決策
＜終了番号：2004＞
The determinant of the stiffness matrix becomes zero ornegative when indicated node has been reached during the Gaussian elimination phase of the solution process. Thismeans that the stiffness matrix is non-positive definite. If this happens at the start of the analysis, the conditionis usually caused by the existence of rigid body modes. It may also be caused by incorrect material properties (e.g.Poisson's ratio greater than 0.5; note that such situations may arise through temperature dependence of properties). Innonlinear cases, the structure may have buckled or reached a plastic limit load. In rubber analysis, it may also be dueto the strain state being in a region where the input data for the strain energy function is invalid. In contactanalysis with friction, lack of normal forces may result in friction being absent. If desired, the program may be forcedto continue by use of the parameter PRINT or the model or history definition option CONTROL. Either one of theseprocedures may be used for restart. Whenever a non-positive definite situation occurs one must exercise caution, as theresultant numerical solution may be infeasible.
ー剛性マトリックスが非正定値であるー
ー非線形の場合は、構造物が座屈したり、塑性限界荷重に達している可能性があるー
解決策
