Marc User's Guide

Marc2014.2User's Guide
MSCの紹介

 
 

他ページ

 
 

Marcの基本操作

モデルを作成する

ばね要素

RBE2

 
 

弾塑性解析

 
 

メモ

崩壊解析

 
 

鋼材の破断

 
 

時刻歴解析

 
 

節点座標の出力

 
 

テーブル

 
 

ガウスポイントの結果

 
 

計算精度

 
 

Marcが立ち上がらない

ショートカットのアイコンをクリックしてMarcを立ち上げても、

Security check failed!
Check that the license server is running
or contact MSC Software Support.
                                OK

と表示され、起動しない。 コマンドプロンプトには

License server is not at or above the minimum required version.
Verify that your license server is at FLEXlm version 11.13.1.0 or above

と表示される。

▸時間を空けて再起動したら、問題なく立ち上げることができた。
もしかするとサーバーが落ちていて、それが復旧したために起動できるようになったのかもしれない。

 
 

エラーメッセージ

Analysis has failed to converge to required convergence
tolerances. One of several error conditions has been
detected and the run aborted. The output will specify
additional messages.

ー解析が収束許容値に収束しなかったー

 
 
The determinant of the stiffness matrix becomes zero ornegative when indicated node has been reached during the
Gaussian elimination phase of the solution process. Thismeans that the stiffness matrix is non-positive definite.
If this happens at the start of the analysis, the conditionis usually caused by the existence of rigid body modes.  It
may also be caused by incorrect material properties (e.g.Poisson's ratio greater than 0.5; note that such situations
may arise through temperature dependence of properties). Innonlinear cases, the structure may have buckled or reached a
plastic limit load. In rubber analysis, it may also be dueto the strain state being in a region where the input data
for the strain energy function is invalid. In contactanalysis with friction, lack of normal forces may result in
friction being absent. If desired, the program may be forcedto continue by use of the parameter PRINT or the model or
history definition option CONTROL. Either one of theseprocedures may be used for restart. Whenever a non-positive
definite situation occurs one must exercise caution, as theresultant numerical solution may be infeasible.

ー剛性マトリックスが非正定値であるー
ー非線形の場合は、構造物が座屈したり、塑性限界荷重に達している可能性があるー

 

解決策

 
 

トップ   新規 一覧 検索 最終更新   ヘルプ   最終更新のRSS